DaBagBoy
Well-known member
- Thread starter
- #1
Took the truck to the beach yesterday, lots of sand ;-)
video from my social media manager....
I managed to get some sand in the bed/tonneau assembly, it started grinding a lot....then a screen message to "calibrate" tried 10 times but need to press the close button to move half an inch until fully closed. Screen shows still half open....
Anyone have an idea if I can just spray water down that slot to wash out what I assume is sand?
video from my social media manager....
I managed to get some sand in the bed/tonneau assembly, it started grinding a lot....then a screen message to "calibrate" tried 10 times but need to press the close button to move half an inch until fully closed. Screen shows still half open....
Anyone have an idea if I can just spray water down that slot to wash out what I assume is sand?
