Anyone else holding off on the Cantrail recall?

[TyPope]

Which service department did you go to? I ask because I was recently at the Anaheim location and saw a CT with the recall "fix" performed and the results were god awful. One side with a nasty gap, and the other with edge sticking out instead of being flush to the body. So apprehensive about getting it done and worrying the job will not be done correctly.

Silver Springs... Virginia

Sponsored

 

[Speedr]

As a data point, just had mine done and came out fine.

Pictures?

 

[RAY INGRASSIA]

One year ownership. They appear well installed. Will pass on having them screw with it.

 

[personage]

Finally got mine done yesterday-- waited two weeks for an appointment after my driver's side rail came off. It beats the look of zip ties, but the alignment is not great. The pieces do not appear to be fully seated. The fronts sit proud. The back is higher than the roof line.

 

[syburtruck]

At least yours don't have the giant blister on the front. It's really disappointing. They did adjust mine a second time and improved them (some.)

 

[Travis64]

Did you guys get $300 credit if your truck was wrapped?

 

[personage]

At least yours don't have the giant blister on the front. It's really disappointing. They did adjust mine a second time and improved them (some.)

I think I have that as well. Looks like a round bump, presumably there is a screw head underneath. I don't think it actually protrudes from the surface, but it looks like it does, depending on the angle.

 

[personage]

At least yours don't have the giant blister on the front. It's really disappointing. They did adjust mine a second time and improved them (some.)

Is this the the sort of "blister" you have? Was your service center able to correct it?

 

[syburtruck]

That's exactly what I have. I was told it depends what parts they get and some have it and some don't. I have had zero luck getting them to correct it.

 

[SeattleTom]

Ugh, the blister looks awful.

I’m going to continue to hold off though I will have to complete some service sometime I’m sure! Hope they get it dialed in before then.

 

[sys700]

I'm holding off. Mine are stuck on there great. If they did separate, I'd probably glue them back on rather than have the dimple and misalignment that will catch at car washes.

Sponsored