Powering Accessories Struggles - Don't let this happen to you!

[TeslaKen]

I looked at digikey, mouser and others for this Rosenberger automotive fitting but no luck. And even if I found it I need to get the right coax wire and all the special crimp tools to make a nice butt splice. I have some posi-taps on the way. Those are the least destructive way without cutting a wire but will not look great. Will not have time to dive in until the weekend to tackle this. I have a small fuse block as well with some busman 3A fuses.

BTW the other end of this wire connects with the same fitting at the footwell area you’re trying to get to. Click on X0848 and you will see it appears to be just below where Hansshow was tapping in.

So then no need to tap in at center console and run a wire over bur rather tap in at the connector in the footwell? I will go look for it. Which taps did you order?

Sponsored

 

[YukonJack]

So then no need to tap in at center console and run a wire over bur rather tap in at the connector in the footwell? I will go look for it. Which taps did you order?

Posi-Tap 20-22 ga. Mini - Pack of 6. The Best Line Tap You'll Ever Use! (Choose Your Gauge Size and Amount) (6, 20-22 Mini) https://a.co/d/03JIESq0

 

[TeslaKen]

Posi-Tap 20-22 ga. Mini - Pack of 6. The Best Line Tap You'll Ever Use! (Choose Your Gauge Size and Amount) (6, 20-22 Mini) https://a.co/d/03JIESq0

OK I ordered some in anticipation of needing them.

Posi-Tap 20-22 ga. Mini - Pack of 6. The Best Line Tap You'll Ever Use! (Choose Your Gauge Size and Amount) (6, 20-22 Mini) https://a.co/d/03JIESq0

Here is what I am seeing when I click on that location you spoke of, is this correct?

Sponsored