Do like i did and put it in test mode to isolate the speakers i showed and take a video You might be hearing it from a different speaker, I was too until I did the service mode test. The front speakers confused me because I was hearing music from it.
I pointed this out a few months ago. Hansshow sent a new harness and the problem remains. And now my rear camera stopped working. This really is not a good product. I’m at the chuck it over the fence part of this install. I have video but it is too large to post.
I thought A started in front of the windshield, but whichever, you know where I mean. Do you have the wiring diagram for that connector? I don't know how many items they are or are not passing through, my blind spot indicator works on the passenger side, didn't test the microphone, I believe the full range speaker works, just not the tweeter, I tested everything on that side in the service menu and on the drivers side. I don't know which pins they are pulling power from because the cable that delivers power is about halfway between connectors and is wrapped in black material. I suspect they are just running the power pins/lines off to their accessory and didn't think about passing it through to the downstream connector at the other end of the cable bundle. Let me know if you want a closer look of some sort.
That is the version I have and you can see that in my install article, as others have said you need to run the speaker isolation test and you will see that your Hansshow cable is cutting off that speaker.
Have you contacted them since and told them the new harness they sent you was useless?
How do you run speaker isolation test? i went to the service icons and none of them show speaker test....
Go to service mode - the icon under the steering wheel is the audio test. Watch the video I posted, you can see which icons I've clicked to do the test.
I have. Time between responses can be very long. Usually 4-5 days.
Typical, I tagged them in this post, let's see if they reply. Keep us posted if you hear anything back from them.
I paid for a replacement wiring harness from Hansshow almost 3 weeks ago, never received tracking and still haven’t heard back from them.
Sure, I know what you mean, since there is only one set of tweeters, but if anyone tries looking them up it won't be listed under B pillar.
Rear camera should not be related. It has two coaxial connectors and runs to the rear control module. But who knows with software...
Does the drivers side connector also not have power wires but the same A2B bus as the passenger side? The Hansshow LED Dash light strip ( ) has a secondary wire that plugs into the drivers side port that looks to be the visual equivalent of the passenger side port. I will get you some photos of the connector ends and I have a continuity meter in my toolbox somewhere...
