Frunk Lid Adjustment - How?

[c379776]

Anyone know how to adjust the frunk lid closure height? I adjusted the 4 stops, but the the motor just pulls the lid down harder and closes to the same height as before the adjustment. I can hear the motor pulling harder so I put the bumpers back the way they were. I don't see anything in service mode or in the service manual.

 

[Jbrazda]

Pull them out and rotate them. Then they should stay. I got my hood perfect and they stay.

 

[Ward L]

Tesla service replaced my frunk hood a couple of weeks ago and it was not set to the correct height on one side. One side was higher than the other. I have a service appointment Tuesday to align it correctly.

 

[c379776]

Pull them out and rotate them. Then they should stay. I got my hood perfect and they stay.

I did that. And once the latching motor grabbed the hood I could hear it straining to pull the hood down the the og position. Sounded like it might damage the motor if I left it that way so I put the bumpers back down.

 

[igs]

I did that. And once the latching motor grabbed the hood I could hear it straining to pull the hood down the the og position. Sounded like it might damage the motor if I left it that way so I put the bumpers back down.

Did you ever figure this out?

 

[c379776]

No. Service call.

 

[HaulingAss]

I've noticed the closing motor has to learn the new position after making adjustments to the bump stops. Just open and close it a few times.

 

[igs]

They are self adjusting so there is nothing to adjust.

https://hamphi.com/en/products/cybertruck-resevdelar-1856561-00-a-s-113302-hood-hinges-and-fittings