Search results

You probably should've called a doctor after the first 4 hours...

Powder coating is the best way. Definitely shop around because prices can vary greatly from shop to shop

I can't see them in the pics, but your wipers can scratch your windshield if they have some debris under them (sand, rock dust, etc) It's common on all vehicles but could happen more easily if the glass is on the softer side

Maybe one of these? https://teckwrap.com/products/midnight-purple-rb20-hd-vinyl-wrap https://metrorestyling.com/products/3m-1080-gloss-plum-explosion-vinyl-wrap-gp258

Pretty dumb to pull something that is much heavier than the weight limit on the winch, even if the Semi wasn't fully "stuck". Could've ended very poorly for someone if the line snapped

Ah, didn't realize the bolts went most of the way through. Even without them I'm sure it was mostly fine (especially being TPU like you said), but thought I'd share What printer did you use? It did a good job with the TPU

Looks great, thanks for sharing the plans. If possible, though, I would recommend printing the parts on their side to change the layer orientation and reduce the risk of them shearing/failing over time.

Hard to tell in the pics but are you sure you didn't have minor rock chips that the water was able to get into/under? Just doesn't seem like damage that would happen from a pressure washer alone

Does that also include accidents where Autopilot disconnected seconds before because of a potential hazard? Or strictly just accidents where Autopilot was active at the moment of impact?

The 3W rubber are great https://www.cybertruckownersclub.com/forum/threads/finally-3w-floor-mats-for-my-cybertruck.31714/

Mine is the same, and my lane departure warnings are also overly sensitive on the left hand side too. I haven't tried recalibrating the cameras yet but it's been on my list. Sucks to hear there's a chance it won't do much, though.

Dang, I hope we didn't get Elon'd again

Xpel makes good products, and it seems to be fairly priced for my area (Socal/LA)

Make sure you go to your local service center if you're stuck on for more than 4 hours

Best green wrap I've seen so far, looks great

I have the standard black and white ones that you'll find all over Amazon. They fit really well, and putting on the rear seat covers doesn't take much time at all (it's the front that are a pain) Only downside is that the folding armrest doesn't close if you put the cover on it, but it's just a...

IIRC I think they initially install it using silicone, but maybe try some 3M VHB? Would probably be better than the silicone (if properly prepped, of course)

Anyone know the details of what changes they made to the cant rails?

I have this one and it's great, I have it in both my Bronco and Model Y. The video quality is good and the cables are really long so you can route it behind the trim if you'd like https://a.co/d/6mzAY8I

At that price I'd do it just so I can constantly tell everyone that it's only $49