Recent content by Kroton

About two weeks.

Yes. I don't know if it couldn't deliver enough amps at the lower state of charge or if the startup demand was higher as the temperature rose.

No. It started and stopped a couple times before the temp hit up.

Oddly, it did in the morning when the temperatures were a bit cooler. It couldn't start it during the afternoon hours. I may get a soft start installed at some point but we were able to get by with a small spot cooler.

Still shows the same but we had an 18 hour power outage on Tuesday and powershare did it's thing seamlessly. As I expected, and contrary to what the installer said, it couldn't reliably start the air conditioner. I'm glad he included it in the protected circuits though. Adding a soft start...

Would be great if you could upload it to printables, makerworld, thingiverse or another site focused on sharing 3d print files.

For any other idiots out there like me, the discharge limit is only available during a power outage.

My app doesn't seem to have this button available yet.

Powershare LRA motor start is 110A. The locked rotor amps for my compressor is higher than that but I didn't recall how much higher. The electrician who did the install said it should fine. My wall connector is installed on a sub panel in my garage.

I had the same issue with the wall connector at first. It reported having WiFi issues though it was connected to WiFi. I had to open a ticket to get that sorted. The powershare page in my app looks the same as yours. I'm not at home so can't test yet.

They had to move my meter to make room for an emergency cutoff and install the gateway. There are two breakers in the emergency cutoff, one feeds the dryer circuit and the other feeds gateway. Everything except the dryer is backed up. We'll see if the truck can provide enough amperage to start...

Just got an email from Tesla starting Powershare has been enabled. I've not had a chance to test yet.

My app shows -- for the gateway version so I may need to open a ticket to make sure it's communicating.

I just got an email from Tesla starting that Powershare has been enabled. Below are the requirements. Cybertruck: 2024.14.3 + Tesla app: 4.32.5+ Universal Wall Connector: 24.12.51 Powershare Gateway: 23.44.906 Powershare functionality for homes with Powerwall, Backup Switch and solar in the...

A Tesla-badged electrician did our install. It was a pretty great experience overall. There was a miscommunication by the design team that he identified right away. The gateway was to be connected to the sub-panel on which the wall connector was wired. This would have resulted in PowerShare...