Search results

The housing is attached with 8 10-32 100 degree countersunk brass instrument screws. Available from Aircraft Spruce and others. I used a soft rubber grommet for the cable pass through. The weatherstrip seal is the same thing used to seal outdoor ductwork.

Looking at it from outside, we drilled a hole just to the right of the back glass as in this photo. We drilled it from the inside so if you do the same be sure and measure carefully so you don’t hit the glass. There is a wire harness above the side curtain airbags you can zip tie the cable to...

Nice design. Looks like an original factory part.

I’ve seen a few really nice 3D printed camera housings but unfortunately, I don’t own a printer at this time. So instead, I bent this up out of one scrap piece of 2024 T3 Alclad aluminum. I decided to route the cable through the interior rather than take the chance of causing wind noise by going...

Side panels need to be at least partially removed

Yes. I found exactly the same conditions. Thanks for the clear pictures and explanation.

Instructions for properly removing/reinstalling the bed side liners are in the repair manual. Best to follow those to avoid breaking clips, etc. They don’t have to all be completely removed, just enough to gain access. I’ll take photos if we do another one.

Remove the plastic side covers to gain access to the left and right cargo track rails and loosen their attaching screws. Then, using large screwdriver or short pry bar push the rails up as high as possible and retorque the attaching screws while applying good pressure. (Helps to have another...

I have both. The Plaid with track package has been parked since I got the truck.

Same here. I’m taking the side panels off to try and understand what’s wrong.

Just wipe it off with naphtha or alcohol. Then try two or three other stainless polishes. Wipe the ones off that are not to your liking. If none are good then just wipe the whole thing off with more naphtha or alcohol. It will look new again. Most products leave a residue. I used some cheap...

Waukesha, just West of Milwaukee. -Marshall Auto Body

I started a thread on this subject a while ago. As more user experience and reviews come out, it’s apparent that this truck is not purpose built for work. The main focus seems to be attention getting appearance, new technology showcase and sporty, off road capability. I am looking forward to...

T Sportline has a video of the truck on a lift. They did not remove the front aluminum skid plate and that's where the undercarraige would Likely mount. if possible. Also someone would have to make a 48V pump and lighting system. Someone mentioned that the Ford Lightning can't accept a plow either.

Is there any provision for mounting/installing a snow plow?

We're in Waukesha. responded to invitation yesterday. Ordered Foundation Series Dual Motor, Dec. 2023-Mar. 2024 Delivery