Search results

I have been perplexed how to carry a spare, so I built this. The criteria are to be strong, off-center so the camera works, low wind resistance, able to swing wide to use the tailgate, and easy to attach the tire without a heave-ho-hold-the-tire while you bolt it down. I used 2x2" square tube...

Hi. I am stuck in the boondocks for a few weeks, and trying to figure out how to turn my 3 hp rock saw from my Tesla outlets. Nothing works, and I am not sure if anything will, but if there is any advice, please step forward…) Saw motor: single phase, 3400 rpm, 120v, 60hz, 15-amp continuous...

The bed divider does not always fit in the bed correctly due to fit tolerance errors, and numerous comments on these threads discuss this problem. Not only did mine not fit, but I broke the latch mechanism on my first trial install. Tesla was very good to replace this, but I replaced this...

FSD 13.2.6 has a new and good feel, largely because of the "almost human" feel to acceleration while passing, better lane control, and better pathway on curves. Complex highway lane changes were done without my stress rising, and highway exits were negotiated in quite a reasonable manner. There...

Dear Tesla, in the spirit of hoping there are meaningful improvements, I have some suggestions since FSD 13.2. Note that I very much like the FSD in my model 3. 1. Cybertruck still does not drive in the center of the lane. This causes safety complications, particularly when passing large...