• Welcome to Tesla Roadster Forum! If you're joining us from Cybertruckownersclub.com, then you may already have an account here.

    If you were registered on the Cybertruck forum as of September 18, 2026 or earlier, then you can login here with the same username and password.

    If you wish, you can remove your account here.

Roadster battery pack (150 kWh) and drive unit - open look

mongo

Well-known member
Joined
May 27, 2024
Threads
3
Messages
3,501
Reaction score
3,024
Location
SE Michigan
Vehicles
Cyberbeast
Country flag
Wouldn't a non usable volume mean that it can't do it?

I don't understand your statement.
Ability versys usefulness.
I can move sand with a shovel; however, it would not be practical for me to dig a quarry by hand.
Charging a 24kWh equivalent tank via a 1.4kW power feed can be done, but not quickly.

AISelect_20261028_114531_Firefox.webp
 

CyberGus

Well-known member
First Name
Gus
Joined
May 22, 2021
Threads
76
Messages
8,535
Reaction score
10,733
Location
Austin, TX
Vehicles
1981 DeLorean, 2024 Cybertruck
Occupation
IT Specialist
Country flag
I used to play Paintball quite a bit.

Filling a CO2 tank is simple, it's mostly liquid at 700+ PSI and the tanks are aluminum.

The advanced nitrogen tanks are another matter. They're aluminum but wrapped in carbon-fiber. Nitrogen (or ambient air) doesn't liquefy, even at the 4500PSI limit of these tanks. Filling them, even from a 4500PSI source, must be done slowly to allow the tank to safely expand. Instantly forcing even a few liters at that pressure will rupture seals, blow out gauges, etc. Plus, the rapid pressure rise causes the tank to heat, reducing capacity.

For the Roadster, I envision a home SCUBA-like tank setup, where a modest pump can fill a large reservoir over time, which can then be transferred to the in-car tank. But, I don't think you can just dump that much air instantaneously. It'll be faster than charging the pack, tho.

I wonder if we'll get a new "NACS+air" connector :ROFLMAO:

Or a SuperSuperCharger :ROFLMAO: :ROFLMAO:
 

gtgarner

Well-known member
First Name
Garlan
Joined
Oct 10, 2024
Threads
7
Messages
178
Reaction score
178
Location
60473
Vehicles
Cybertruck ands P3D
Occupation
Retired
Country flag
I used to play Paintball quite a bit.

Filling a CO2 tank is simple, it's mostly liquid at 700+ PSI and the tanks are aluminum.

The advanced nitrogen tanks are another matter. They're aluminum but wrapped in carbon-fiber. Nitrogen (or ambient air) doesn't liquefy, even at the 4500PSI limit of these tanks. Filling them, even from a 4500PSI source, must be done slowly to allow the tank to safely expand. Instantly forcing even a few liters at that pressure will rupture seals, blow out gauges, etc. Plus, the rapid pressure rise causes the tank to heat, reducing capacity.

For the Roadster, I envision a home SCUBA-like tank setup, where a modest pump can fill a large reservoir over time, which can then be transferred to the in-car tank. But, I don't think you can just dump that much air instantaneously. It'll be faster than charging the pack, tho.

I wonder if we'll get a new "NACS+air" connector :ROFLMAO:

Or a SuperSuperCharger :ROFLMAO: :ROFLMAO:
I'm not worried. One thing Tesla is good at is - getting tech to work.
 

ginmqi

Member
Joined
Dec 7, 2025
Threads
0
Messages
21
Reaction score
14
Location
Midwest
Vehicles
2022.5 Model S w/FSD V14.3 Lite
Occupation
Healthcare
Country flag
I'm not worried. One thing Tesla is good at is - getting tech to work.
Absolutely.

Lars have said they are working on a system to cut the refill time down to 30min. I think behind the scenes they really want to make an on-board compressor work but I imagine there is a chance that those who have Thrust/Rocket will need to use an external air compression source.

The 10k psi compressor linked above shows the engineering challenge involved. It would be stupid easy to NOT incorporate an onboard compressor and just have owners buy a Tesla compressor and hook it up....but that means no refill on the go and limited usefulness in on-demand high performance.

So you now have to package a reliable, 10k psi air compressor into the car's design/chassis with power source, lines for air and power connecting between the car and the compressor and the COPV, be reliability used and tolerate extremes of car duties (for the very rare few that may actually daily drive/use a Thrust/Rocket car on the street).

If anyone company can get it done, it's Tesla. But I would caution a reserved optimism.
 

gtgarner

Well-known member
First Name
Garlan
Joined
Oct 10, 2024
Threads
7
Messages
178
Reaction score
178
Location
60473
Vehicles
Cybertruck ands P3D
Occupation
Retired
Country flag
Absolutely.

Lars have said they are working on a system to cut the refill time down to 30min. I think behind the scenes they really want to make an on-board compressor work but I imagine there is a chance that those who have Thrust/Rocket will need to use an external air compression source.

The 10k psi compressor linked above shows the engineering challenge involved. It would be stupid easy to NOT incorporate an onboard compressor and just have owners buy a Tesla compressor and hook it up....but that means no refill on the go and limited usefulness in on-demand high performance.

So you now have to package a reliable, 10k psi air compressor into the car's design/chassis with power source, lines for air and power connecting between the car and the compressor and the COPV, be reliability used and tolerate extremes of car duties (for the very rare few that may actually daily drive/use a Thrust/Rocket car on the street).

If anyone company can get it done, it's Tesla. But I would caution a reserved optimism.
I can't see them using a simple air compressor, however an onboard hydraulic type unit might work if the heat of the unit can be regulated properly.


Anywhoo - my best guess is that they will be installing something that no one has invented yet.
 

ginmqi

Member
Joined
Dec 7, 2025
Threads
0
Messages
21
Reaction score
14
Location
Midwest
Vehicles
2022.5 Model S w/FSD V14.3 Lite
Occupation
Healthcare
Country flag
I can't see them using a simple air compressor, however an onboard hydraulic type unit might work if the heat of the unit can be regulated properly.


Anywhoo - my best guess is that they will be installing something that no one has invented yet.
I wouldn't be surprised. Their tradition is to blaze new trails and make the impossible merely late. Love what they are doing with the new Roadster!!
 

CyberGus

Well-known member
First Name
Gus
Joined
May 22, 2021
Threads
76
Messages
8,535
Reaction score
10,733
Location
Austin, TX
Vehicles
1981 DeLorean, 2024 Cybertruck
Occupation
IT Specialist
Country flag
Anywhoo - my best guess is that they will be installing something that no one has invented yet.
My guess: baking soda and vinegar

Or Diet Coke and Mentos
 
 
Top