Recent content by ShockAuto

Glad to see more people doing it! it makes the truck so much better

The issue is the other panels can’t actually fall off due to some fasteners but will get super loose and rattle, so most likely they will only replace upon customer complaint

Around the 70k vin range, my 74k vin has the new glue on the front, fenders, rear fender, sail but not on the doors or tailgate, not sure they have even fixed the doors and tailgate yet from factory

My cybertruck was repurchased due to all my panels having this issue but now tesla is using new glue so the panels that you will get replaced with will have new glue

Mice got to it, they should've used a more tough foam for sound insulation, I am planning on adding more sound insulation up there on my truck to see if it lessens the whistle noise

Mines in for the same thing, if they can't figure it out then maybe it would be worth putting my go pro under the frunk with my frunk plastic liner out so I can really hear what it is, if it really is the motor and there's no fix then maybe I will just add more sound isolation under the frunk area

yep, my other truck did this last winter and now my new truck just started doing it this winter, going to service and they will replace it

Yes this is basically what Tesla does now to fix it

I'm in New Hampshire but have wrapped about 80 and have my own cybertruck so if I can help in any way let me know, I prefer to take off the tailgate and lights so I can wrap fully around the edges with no issues, I would hope at this point all shops would since how easy it is to remove parts...

yep here

Eventually all the panels with the old glue will have issues like this, my truck sadly had this happen as well

Do you have any mods that plug into that port on the right side of the dash?

How new is it? I thought they were making a new harness for it to fix the issue but I guess not, I would message them and say it's doing the hissing sound

Yeah I feel it makes the whole cabin feel more stable, having all 4 doors wobble at high speeds is not great. I also recently had a car normal door apart and there was a huge bracket through the middle that was like glued to act as a reinforcement, not sure why they just got rid of any support

I did 1-2 ish layers of that stuff on my doors, not needed to do 2 but was in there so might as well. I notice the arm vibration is almost all gone, maybe a slight bit near 90 but that's it