• Welcome to Tesla Roadster Forum! If you're joining us from Cybertruckownersclub.com, then you may already have an account here.

    If you were registered on the Cybertruck forum as of September 18, 2026 or earlier, then you can login here with the same username and password.

    If you wish, you can remove your account here.

Recent content by iantopaladin

  1. iantopaladin

    Bar Keepers Friend steel cleaner applied -- result photos

    Place barkeepers on microfiber sponge thing. apply circular, with the grain, however you want to apply barkeepers. Just be conservative on the application. Use glass cleaner or windex to wipe it off with microfiber towel. then spray off with water hose or high pressure thingy. I do not nor...
  2. iantopaladin

    Bar Keepers Friend steel cleaner applied -- result photos

    All of the photos are after.this was before
  3. iantopaladin

    Bar Keepers Friend steel cleaner applied -- result photos

    Whole truck 30 minutes no elaboration needed, apply minimal amount in circular pattern, dries quickly, it needs to be removed as soon as possible with microfiber.. winded or glass cleaner removed the compound, or was with high pressure washer on each section or door panel. This is what I did...
  4. iantopaladin

    Bar Keepers Friend steel cleaner applied -- result photos

    None, made the laser etching pop a little more. Do not apply liberally. Minimal amount.
  5. iantopaladin

    Bar Keepers Friend steel cleaner applied -- result photos

    None. Just remember do not use frequently. Not sure why, just told that.
  6. iantopaladin

    Bar Keepers Friend steel cleaner applied -- result photos

    I applied a less than liberal amount and utilized windex to remove the metal polisher. Do not leave on too long, wipe immediately. Do not reuse the microfiber towel, it turns brownish black.
Top