I worry the cast aluminum frame would not hold up well. Plowing takes a lot of force to the front. If it is appropriate, I certainly would go for a V plow, stainless steel, naturally.
So what has been falling off the CT? Seems to be a failing of a glue system, and some news reports say that stainless panels have fallen off. Surely the large sheets of stainless are not just attached with glue? It is a long way to the Dealer, and I don't want to do that if there is no actual...
Maybe not everyone's experience, but it just does not do turning from paved road onto dirt road. Often comes to a shuddering stop. On dirt roads and even paved roads without white lines, it takes its half out of the middle. Plays it tight when meeting another car. It can get somewhat thrilling...
The CT should be able to do this instead of greedy feeding at the maximum power rate, costing me and the environment top dollar, it could easily calculate the minimum power draw so it is fully charged when next needed. How about software upgrade? My last power bill was over $220 for a partial...
If I want to set the charging rate to 30 amps, or less, the CT defaults back to 48 amps every day. If I once forget the find the screen that sets the charging rate, then i am screwed for another month. Is there a way to tell the truck that the new maximum should be lower than the highest...
My new CT is being charged in my carport. I installed a 48 amp circuit for this alone. I just got my first electric bill. It is still a lot of money. For the first month I had a zero energy charge, a generally green power supplier that is currently fully offset by my 5.1 KW solar array in the...
The twin hooks on the front are the key. Unbolt those two and bolt on a good 2" square box tubing cross bar, schedule 40 or better. Then mount standard plow frame receiver on this cross bar. There is adequate 12VDC power, right? Not sure we are going to have a 48 volt plow rig for a while. Add a...
Not sure if the right category, but I want to ask about driving the truck. My current habits might seem strange to some. I try to not use the brake, ever. I am only partly successful. Using the brake is a sign of defeat. All that energy to gain momentum and you just put it into waste heat in a...
Tesla.com advertises only the one Wall Charger. It does not list it as being compatible with the CT. Should I wait until the Wall Charger is updated or is it a safe buy now? I have a 150 foot run to the CT garage and will need some summer months to get the electrical system in place. Always...
Based on this discussion, no wrap for me. But I do need my company name and logo on sides. What is best? Paint, vinyl, epoxy paint, magnetic? Do magnetic even work on stainless? Other choices?